The operating instructions for the automatic die-cutting machine are as follows:
Power-on Preparation
Check that the power supply voltage is three-phase 380V and ensure the equipment is properly grounded.
Clean the die-cutting area, ensuring it is free of foreign objects.
Install the appropriate die-cutting dies and adjust the die pressure to a suitable level (usually 5-10 kg/cm²).
Parameter Settings: Adjust the die-cutting depth according to the material thickness. The recommended initial value is 80% of the material thickness.
Set the die-cutting speed to 2400 passes/hour (this can be adjusted according to material characteristics; for example, shrink film is recommended to be reduced to 2000 passes/hour).
Enter the die-cutting pattern size (maximum supported 350x350mm), ensuring it matches the die.
Trial Run and Adjustment: Run the equipment under no-load for 3-5 minutes, observing for any abnormal vibrations or noises.
Place test material and perform a trial cut to check the die-cutting accuracy (which should be controlled within ±0.1mm).
Fine-adjust the pressure or speed based on the trial cut results until the cut is smooth and burr-free.
Formal Production: During continuous production, monitor the unwinding and rewinding status (maximum diameter 800mm) to prevent material accumulation or breakage.
Check die-cutting quality every 30 minutes and record parameter fluctuations.






